Eucatex


  • Eucatex Latex PVA X-Power



The colors and patterns on this site are only for reference, there may be divergence between the colors on the screen and the real colors of products. Availability on request.

Velvety finishing and excellent covering which make all the difference to interiors.

Eucatex Latex PVA X-Power is indicated for painting external and internal surfaces of plaster, acrylic mass, textures, concrete, fiber cement, repainting on PVA and internal surfaces covered with putty and gypsum. It is a product which is easy to apply, has little splashing and a smooth perfume and that provides an extremely fine velvety matt finishing, bringing charm and sophistication to interiors.
 

Composition

Resin with a base of aqueous dispersion of vinylic polymers, pigments absent of heavy metals, inert mineral loads, glycols and ethoxyl and carboxylic tensoactives.
This product is classified according to standard NBR 11.702 of November 1991 of the ABNT (Brazilian Technical Standards Association) Type 4.5.2.
 
  with water m2/coat  

Spackle or acrylic paste, repainting, plaster, concrete blocks, gypsum, fiber cement
or concrete
 
First coat: 20% to 30%
Others: 10% to 20%
8,75 to 13,75
35 to 55
175 to 275
Quart (900 ml)
3.6 liters
18 liters
 
 
Two to three coats with an interval of 4 hours Dilute with 30% of water, pressure between 2.2 and 2.8  f/cm2 or 30 and 35 lbs/in.2 At touch: 2 hours Final: 12 hours
 
Apllication
Wool roller Paintbrush Flat paintbrush

As per ABNT NBR 13.245.

  • Preparation: the surface must be firm, cohesive, clean, dry, without dust, fatty materials, soap and mould. Before starting the painting, note the guidelines to follow:
  • Surfaces with loose flakes or coated in lime (whitewash): they must be scraped off or brushed off until the complete removal of the paint residue. Then apply the Eucatex Wall-Preparing  Undercoat, as indicated on the packaging.
  • Mould surfaces: wash them with a solution of water mixed with sanitary water in the proportion of 1:1, rinse them and wait for them to dry. This process is necessary to correct the possible causes of the mould being generated;
  • Surfaces with fatty stains: wash them with a solution of water and neutral detergent, rinse them and wait for them to dry.
  • New plaster: wait for the cure for at least 30 days. Apply 1 or 2 coats of Eucatex Acrylic Sealer, as per the recommendation of the packaging, and if necessary level the surface, applying 2 or 3 coats of Eucatex Acrylic Putty (wet areas) or Eucatex Putty (areas not wet).
Weak plaster (low cohesion): apply Eucatex Wall-Preparing Undercoat as recommended on the packaging and level the surface, applying 2 or 3 coats of Eucatex Acrylic Putty (wet areas) or Eucatex Putty (areas not wet ).