Eucatex


  • Eucatex Dyeing Varnish



The colors and patterns on this site are only for reference, there may be divergence between the colors on the screen and the real colors of products. Availability on request.

It alters the tonality of new woods, besides renewing and beautifying surfaces

Eucatex Dyeing Varnish is a product indicated to varnish and alter the tonality of new internal and external woods, besides beautifying and renewing surfaces which have undergone fading and wear of the original tonality due to the action of time and bad weather.

It provides a fine gloss finishing, which highlights even more the natural veins of Woods, and it is easy to apply, with a high penetration power, quick drying, high yield and great adherence top the substratum.

Gloss finish

Composition

Alkyd resin, solvents of the aliphatic and aromatic hydrocarbon type, organometallic dryers, inorganic pigments and additives. It does not contain benzene and heavy metals.
This product is classified according to standard NBR 11.702 of the ABNT (Brazilian Technical Standards Association) Type 4.3.1.2.

  with Eucatex Turpentine m2/coat  
Wood

First coat:
20% to 25%
Others: 15%

2 to 3
8 to 12
35 to 45

1/16 of Gallon (225 ml)
¼ of Gallon (900 ml)
Gallon (3.6 liters)


 

Two to three coats with an
interval of  12 hours

Drying Period: To touch: 4 to 6 hours
Final: 24 hours


Application
Foam roller Paintbrush *Spray gun

*For the Spray gun, use  pressure between  2.2 and 2.8 kgf/cm² or 30 to 35 lbs/in.²
  • For a perfect finishing, in new woods of non-wettable areas, use Eucatex Sealer for Wood as a primer. On new external woods, apply the Eucatex Dyeing Varnish directly, diluting the first coat 1:1 with turpentine and continuing with coats and dilution indicated above;
  • Removers in the wood can cause problems of drying and finishing in the coatings applied after the removal. If you use removers, clean the wood effectively to minimize the  occurrence of these problems;
  • The practical yield can vary due to the method of application, geometry of the structure, rugosity and absorption of the surface, thickness of the product layer deposited, atmospheric conditions and application technique;
  • When using the product on new woods, observe the dilution item carefully for the first coat, as the recommendations described are factors of paramount importance for the good performance of the product. Remark: when applying with a foam roller, it is natural for microfoam to appear, which will disappear during the drying process;
  • To attain the tonality required, we suggest applying at least 3 coats, as the varnish, being a translucent product, tends to undergo interference from the tonality of the wood applied.

According to ABNT NBR 13.245.

  • Preparation: the surface must be firm, cohesive, clean, dry, without dust, fatty materials, and mould.
  • Surfaces with gloss: they should be sanded until they are completely matt before starting to apply the varnish.
  • Surfaces with fatty stains: they should be washed with a solution of water and neutral detergent. Then, rinse them well, wait for them to dry and apply the product.
  • New woods not dry: they must receive successive applications of Thinner until the complete elimination of the natural resin of the wood, which can damage the paint.
  • New dry woods: sand the surface to eliminate splinters and remove the residue. In non-wettable areas, apply a coat of Eucatex Sealer for Concentrated Wood, diluted 100% with Eucatex Thinner. After the drying, sand again and eliminate the dust.
  • Repainting: remove loose parts, sand to remove the gloss and make a new application.